Count it yourself · Part 2 of 2

Trust, but count: watch data, manual splits and pool length

Pool watches are good at totals and less good at the reps that matter. How to cross-check against the pace clock, confirm the pool length, and review pace and stroke count together after a session.

9 min read Illustrative data

A swimming watch is a remarkable thing to wear in a pool. It counts lengths, estimates strokes, times rests and produces a tidy summary before you have dried off. It is also guessing. It infers each turn from the movement of your wrist, and some turns are easier to guess than others.

None of this makes watch data useless. It makes it data that needs a second source now and then. This note covers three habits: checking the watch against manual splits, confirming the pool length before you trust any pace, and reviewing pace and stroke count together, rep by rep, once the numbers are clean.

Where watch data tends to go wrong

Lap detection works best on continuous freestyle with clean, consistent turns. It is more likely to miss or invent a length when:

  • you make an open turn or stop briefly at the wall, for example after passing someone;
  • you push off during rest to make room in the lane, which can look like a short length;
  • you swim drills, kick sets or mixed strokes, which change the wrist movement the watch relies on;
  • you stop mid-length, stand up, or adjust goggles;
  • the pool length setting on the watch does not match the pool.

The first four create errors in individual reps. The last one quietly scales every number in the session.

Cross-check against the pace clock

Once every few weeks, take manual splits for one main set and compare them with what the watch recorded. Read the pace clock at the start and finish of each repeat and write the times down at the wall, or say them out loud and write them down at the end of the set.

One 8 × 100 m set, pace clock against watch, 25 m pool Illustrative data

Rep Pace clock Watch distance Watch time Watch pace per 100 m What happened
1 1:56 100 m 1:56 1:56 Match
2 1:56 100 m 1:57 1:57 Lap button pressed a second late
3 1:56 100 m 1:55 1:55 Lap button pressed a second early
4 1:57 100 m 1:57 1:57 Match
5 1:57 75 m 1:57 2:36 Open turn after a pass; one turn missed
6 1:58 100 m 1:58 1:58 Match
7 1:59 125 m 2:21 1:53 Push-off during rest logged as a length, with 22 s of rest added
8 2:00 100 m 2:00 2:00 Match
Set 15:39 800 m 16:01 2:00 avg Manual average 1:57

The total distance is correct, which is exactly why errors like these go unnoticed. One rep lost a length and another gained one, so the summary looks right. But rep 5 appears to be the slowest 100 of the season and rep 7 the fastest, and the set average is three seconds slower than what was actually swum.

The fix is not to stop using the watch. It is to know which reps to distrust, and to edit or ignore them before drawing conclusions.

Check the pool length before you trust any pace

Every pace on the watch is distance divided by time, and the distance is simply the number of lengths multiplied by the pool length you entered. If that setting is wrong, every pace and every total is wrong by the same proportion.

The most common mix-up is between 25 metre and 25 yard pools. A yard is 0.9144 m, so a 25 yd length is 22.86 m.

Ways to confirm the length, from most to least reliable:

Confirming pool length

Check What to look for Notes
Ask the facility Posted lane length, or ask staff The quickest answer; some pools have more than one configuration
Lane markings Distance markers on the deck or wall Look for “m” or “yd” on signage
Backstroke flags Distance from flags to wall Typically 5 m in metre pools and 15 ft in yard pools
Your stroke count Count compared with a pool you know A 25 yd length usually takes one or two fewer strokes than 25 m
Lengths per 100 4 lengths, or 3 in a 33⅓ m pool Odd lengths such as 20 m or 33⅓ m need their own watch setting

If you swim in more than one pool, check the watch setting at the start of every session. It takes five seconds and protects the whole log.

A post-session review: pace and stroke count together

Pace alone hides how you produced it. Stroke count alone hides what it cost. Plotted together, rep by rep, they show whether a set held its shape or slowly came apart.

For each repeat you need two numbers: the time from the pace clock, and the average strokes per length. Count every length the way the first part of this series describes, and average them; a 100 m repeat counted as 17, 17, 18, 18 averages 17.5.

Post-session review: pace per 100 metres plotted against average strokes per length for two sessions of the same 8 × 100 m set (illustrative data) A scatter plot. The horizontal axis is time per 100 metres from 1:50 to 2:02, faster to the left. The vertical axis is average strokes per 25 metre length from 16 to 21. Dashed diagonal guide lines mark SWOLF 47, 49 and 51, where SWOLF is seconds per length plus strokes per length; lower and further left is more economical. In the week 1 session, reps 1 to 5 sit near 1:56 to 1:57 and 17.5 to 18.5 strokes, then reps 6 to 8 drift up and to the right, ending at 2:00 and 20 strokes, SWOLF 50. In the week 4 session the same set stays tight, from 1:53 and 17 strokes to 1:56 and 18.25 strokes, SWOLF 45.25 to 47.25. All values are illustrative, not records. Pace against stroke count, rep by rep Week 1: 8 × 100 m Week 4: same set SWOLF guide: seconds per length + strokes 1:501:521:54 1:561:582:002:02 Time per 100 m (min:s), faster to the left 161718 192021 Average strokes per 25 m length SWOLF 47 SWOLF 49 SWOLF 51 ↙ faster with fewer strokes (lower SWOLF) Week 1, rep 1: 1:56 per 100 m, 17.5 strokes per length, SWOLF 46.5 Week 1, rep 2: 1:56 per 100 m, 17.75 strokes per length, SWOLF 46.75 Week 1, rep 3: 1:56 per 100 m, 18 strokes per length, SWOLF 47 Week 1, rep 4: 1:57 per 100 m, 18 strokes per length, SWOLF 47.25 Week 1, rep 5: 1:57 per 100 m, 18.5 strokes per length, SWOLF 47.75 Week 1, rep 6: 1:58 per 100 m, 19 strokes per length, SWOLF 48.5 Week 1, rep 7: 1:59 per 100 m, 19.5 strokes per length, SWOLF 49.25 Week 1, rep 8: 2:00 per 100 m, 20 strokes per length, SWOLF 50 Week 4, rep 1: 1:53 per 100 m, 17 strokes per length, SWOLF 45.25 Week 4, rep 2: 1:53 per 100 m, 17.25 strokes per length, SWOLF 45.5 Week 4, rep 3: 1:54 per 100 m, 17 strokes per length, SWOLF 45.5 Week 4, rep 4: 1:54 per 100 m, 17.25 strokes per length, SWOLF 45.75 Week 4, rep 5: 1:54 per 100 m, 17.5 strokes per length, SWOLF 46 Week 4, rep 6: 1:55 per 100 m, 17.5 strokes per length, SWOLF 46.25 Week 4, rep 7: 1:55 per 100 m, 17.75 strokes per length, SWOLF 46.5 Week 4, rep 8: 1:56 per 100 m, 18.25 strokes per length, SWOLF 47.25 Week 1 rep 8: drifted rep 1 Week 4 rep 1 rep 8
Pace per 100 m against average strokes per length for the same 8 × 100 m set, four weeks apart. Dashed lines join combinations with the same SWOLF score. Illustrative data.
Text description of this diagram

How to read it: further left is faster; further down is fewer strokes; the dashed diagonals join combinations of time and count with the same combined score (seconds per length plus strokes per length). Moving down and to the left is more economical.

Week 1 (circles): reps 1 to 5 sit close together, from 1:56 at 17.5 strokes to 1:57 at 18.5. Reps 6, 7 and 8 drift up and to the right, ending at 2:00 and 20 strokes. The stroke was shortening as the set went on.

Week 4 (squares): the whole set sits lower and further left, from 1:53 at 17 strokes to 1:56 at 18.25. The drift is still there, but it is small.

The full values are in the table below the diagram.

The data behind the review diagram: 8 × 100 m on 2:30, 25 m pool Illustrative data

Rep Week 1 time Week 1 strokes per length Week 1 SWOLF Week 4 time Week 4 strokes per length Week 4 SWOLF
1 1:56 17.50 46.50 1:53 17.00 45.25
2 1:56 17.75 46.75 1:53 17.25 45.50
3 1:56 18.00 47.00 1:54 17.00 45.50
4 1:57 18.00 47.25 1:54 17.25 45.75
5 1:57 18.50 47.75 1:54 17.50 46.00
6 1:58 19.00 48.50 1:55 17.50 46.25
7 1:59 19.50 49.25 1:55 17.75 46.50
8 2:00 20.00 50.00 1:56 18.25 47.25
Average 1:57.4 18.53 1:54.3 17.44

SWOLF here is the time for one 25 m length plus the strokes for that length, so a 1:56 repeat at 17.5 strokes scores 29 + 17.5 = 46.5. It is a convenient way to see time and count in one number, but it depends on height, pool and turns, and it can be gamed by gliding. Use it to compare your own repeats, not to compare swimmers.

The most useful reading of the diagram is not the improvement between weeks, which may come from many things. It is the shape within week 1: three reps of drift at the end of the set, with stroke count rising faster than time. That points to holding the stroke length under fatigue as the thing to work on, which is a more specific lesson than “swim faster”.

Turning data into a habit

A sustainable routine looks like this: wear the watch every session, take manual splits for one main set every few weeks, and once a fortnight plot or tabulate one set as pace against stroke count. Correct the obvious errors before you look at trends. If you edit a rep, note why.